Categories

System glitches and false alarms can be aggravating, and even worse, could prevent your home security system from working how it should. Thankfully, most problems, from false alarms to dead batteries, are straightforward to correct. Take a look at our tips for troubleshooting your home alarm system in Ogden. We’ll help keep your family shielded and your system running as it should.

Test Your Home Security System In Ogden

One sensible way to troubleshoot your property’s security is to test it! The latest systems have a test mode so you don’t by accident initiate an emergency response from monitoring agents. After moving to test mode, do the following:

• Turn on your system as you normally would when you head out.
• Open a window or door that uses a contact sensor, or test other sensors. Shut the door or window so it doesn’t trigger the alarm when you turn the system back on.
• Permit the alarm to go off for 60 seconds to make sure a message is delivered to the security provider and an entry is made in the alarm system log.
• Proceed to test devices as needed
• Review the systems’s activity log to confirm proper function.

Rest assured, monitoring professionals will know that your alarm system is undergoing a test. Be sure to switch off test mode when you’re done. It’s smart to test monthly or whenever you change your home’s internet or phone service.

Check The Position And State Of Motion Sensors

Although an essential aspect of your alarm system, motion detectors are notorious for false alarms. Prevent them with a few straightforward troubleshooting steps.

• Perform a visual inspection. Is there anything that could move within the detection path of the sensor, like drapery caught in a breeze?
• Is the sensor covered in dust? Dirt, cobwebs, and debris can lead to poor performance. Make sure the face is clean.
• Does the motion detector come with pet immunity you can turn on? Some sensors can be programmed to disregard pets weighing up to 100 pounds.
• When was the battery changed? A low battery might impact performance or cause false alarms.
• Is a heat source impairing the sensor? Too much heat from a fireplace, direct sun, or something else can cause an alarm.

Keep Batteries On Hand And Watch Out For Low Battery Signals

One of the great things about new home security systems is that they’ll tell you when batteries are dying. If your system is equipped with a control panel or mobile app, you’ll usually discover notifications there. Depending on your system, you might hear an occasional beep when batteries are getting low. 

Motion sensors, contact sensors, smoke detectors, and other wireless components have batteries that will have to be replaced every year or two. It’s wise to keep batteries around and create a replacement schedule. Many systems also have a rechargeable backup battery for the central control panel. This backup battery helps keep your system functioning if your power goes out and should recharge once power is restored. If it doesn’t recharge, you will have to replace it.

Troubleshooting Is Simple With ADT Home Security In Ogden 

As the foremost name in home security, ADT creates systems that provide unrivaled functionality and convenience. Switching to test mode is straightforward through MyADT.com or the ADT+ app, and you’ll always receive updates when a battery is running low. Get in touch with Secure24 Alarm Systems, an authorized ADT dealer, to get more details and design a system perfectly suited to your Ogden home. Place a call to (801) 903-1699 or complete our form today!